Furnace Repair Windsor, CO

When your furnace stops working on a freezing Northern Colorado night, you need help fast. Triple Point Heating & Air provides dependable furnace repair for homes and businesses in Windsor, CO and across Northern Colorado. We find the root cause of the problem, explain your options in plain language, and restore your heat as quickly as possible.

As a family-owned Windsor company with more than 15 years of HVAC experience, we repair gas, electric, and oil forced-air furnaces, along with heat pumps and boilers. If you lose heat after hours, our 24/7 emergency service is here for you. Not sure what’s wrong? Contact us and we’ll help you figure out the next step.

Signs Your Furnace Needs Repair

Furnaces rarely fail without warning. If you notice any of the following, it’s worth having a technician take a look before a small problem turns into a no-heat emergency:

• No heat, or weak heat, coming from your vents
• A furnace that turns on and off repeatedly (short cycling)
• Banging, rattling, squealing, or scraping noises
• A yellow or flickering burner flame instead of a steady blue one
• A furnace that runs constantly but never seems to warm the house
• Rooms that stay noticeably colder than the rest of the house
• Heating bills that climb without any change in how you use your home
• A furnace that won’t start or won’t stay lit

Common Furnace Repairs We Handle

Our technicians have the experience to diagnose and fix the full range of heating problems, including:

• Ignition problems: A worn hot surface ignitor or a faulty pilot assembly is one of the most common reasons a furnace won’t start.
• Dirty or failed flame sensors: A sensor coated with residue can make a furnace light and then shut off after a few seconds.
• Blower motor and capacitor issues: Weak airflow or a blower that won’t run often points to a worn motor or failed capacitor.
• Inducer motor and pressure switch problems: These safety components keep combustion gases venting properly, and a failure will stop the furnace from running.
• Thermostat and control board problems: Sometimes the furnace is fine, but the signals telling it what to do are not.
• Gas valve and limit switch repairs: Faulty controls can cause short cycling, overheating, or no heat at all.
• Condensate drain clogs: High-efficiency furnaces produce condensation, and a blocked drain can shut the system down.
• Cracked heat exchangers: This is a safety issue because it can allow combustion gases, including carbon monoxide, into your home. If we find one, we’ll show you and explain your options.

Why Northern Colorado Winters Are Hard on Furnaces

Northern Colorado winters put real demands on heating equipment. Cold snaps can keep your furnace running for long stretches, sudden temperature swings mean frequent starts and stops, and dust and pet hair can clog filters and burners over the season. When a system is working that hard, one worn part can turn into a no-heat call quickly. The best protection is catching problems early with annual furnace maintenance before the heating season begins.

Furnace Repair or Replacement?

Not every furnace is worth fixing. A repair usually makes sense when the system is relatively young and the problem is modest. If your furnace is more than 15 to 20 years old, needs repairs again and again, has a cracked heat exchanger, or is driving up your heating bills, replacement is often the smarter investment. We’ll give you an honest recommendation and a free, no-obligation estimate on major repairs, with no pressure. Learn more about furnace installation in Windsor, or ask about our HVAC financing options. Members of our TPS Service Agreement also save 10% on repairs.

What to Do If Your Furnace Stops Working

A few quick checks can sometimes restore your heat, or at least help us diagnose the problem faster:

• Make sure the thermostat is set to “heat” and the temperature is above the current room temperature.
• Check your breaker panel, and the power switch on or near the furnace.
• Replace the air filter if it’s dirty or clogged.
• Make sure the gas supply valve to the furnace is open.
• Check that supply and return vents are open and the area around the furnace is clear.

Safety comes first. If you smell gas, leave the house right away and call your gas utility or 911 from outside. If a carbon monoxide alarm sounds, get everyone outside and call 911. For anything else, shut the furnace off and contact us.

Serving Windsor and the Surrounding Communities

Windsor is home. It’s where we’re based, so Windsor homeowners and businesses get our local knowledge, fair pricing, and faster response times when the furnace quits. We also provide furnace repair throughout Weld and Larimer Counties, including Fort Collins, Loveland, Greeley, Timnath, Severance, Johnstown, Milliken, Wellington, Eaton, Ault, and Nunn. Visit our service area page for the full list, or contact us to confirm we cover your address.

Don’t tough out the cold. Contact Triple Point Heating & Air today to schedule furnace repair in Windsor, CO and the surrounding area. Looking for more? Explore all of our heating services, including furnace installation and furnace maintenance.